ET-105-C-230-SDX10Description

MULTI-PACK OFFER!! 10 pack of 12 Volt, 20 - 105 VA low voltage electronic transformers fitted with an encapsulated 2M2 potentiometer to enable independent self dimming.and other applicable Regulations. Compliance to the EC EMC and Low Voltage Directives may be invalidated if not used or installed according to the published specification. Electronic Transformers operate at high frequencies. The output voltage cannot be measured on a standard voltmeter. The output leads should not be separated by more than 10mm and should be kept to a minimum length to achieve optimum regulation and EMC suppression. Electronic Transformers are not recommended for parallel rod or tensioned wire lighting systems. Observe dimmer manufacturer's recommended load ratings. Electronic Transformers should be located in well ventilated areas and should not be covered or enclosed by insulating materials. This self-dimmable model includes a pre-wired dimmer control. The Mode ET-105-C-SD is fitted with a pre-wired boxed potentiometer to allow for localised control.